LeMotech Junction Box, Electrical Box IP65 Water Resistant Dustproof ABS Plastic Project Enclosure for Electronics White, External Size 5.9 x 4.3 x 2.8 inch

Size of box reviewed: 5.9 x 5.9 x 2.8 (150mm x 150mm x 70mm).I found the material of the box allowed for easy modifications with needed holes to be drilled. The lid fits nicely on the box, with a built-in seal around the edge to keep it weatherproof. Overall, I was very pleased with the quality of workmanship and material of this project box.My project required several holes to be drilled in my box. The pre-scored 1" (25 mm) knock-outs are nice, but I needed a 1-1/8" (28 mm) hole where two of those knock-outs were located. So, I drilled a small pilot hole in the center of the knock-outs and then used a hole-saw attachment on my drill to bore the required 1-1/8" (28mm) hole (see pic with yellow hole saw). My project was to supply and distribute multiple voltages to be used by different devices. I mounted 2 ScanStrut weatherproof USB-A ports (ASIN B071WXWS9C) on the sides of the box. Inside the box, I also mounted a 6 VDC buck converter (ASIN B07SGJSLDL) and a 12 VDC buck/boost converter (ASIN B07N3QT628). From each of these converters, I will route the outputs through the cable glands mounted on the top of the box. The LeMotech box comes with 2 black cable glands, but I used 2 grey ones (ASIN B094ZDSD86) instead of the ones that came with the box. These required 2 custom 12 mm holes to be drilled in the top side of the box..This has turned out to be one of the smoothest project box jobs I have done. Hints for good results: drill holes slowly into the material, and do NOT force the drill/saw into the material. When sawing, proceed slowly so as to CUT the material, rather than BURN it. Since this project, I have ordered another one of the boxes of this same size, as well as another in a smaller size, for use in other projects.

worked great to make a protective case to splice together 6/4 wire with din rail dinkle connector.

Excellent quality and good value. If you intend to use the black box "2x NPT1/2"Cable Gland", note that they are smaller than the preformed "knockout" locations for them on the sides. Using a drill bit of the correct size will work, but if you plan to knock out the "holes" on the sides, the resulting holes are too large for the glands. I punched them out and then realized the holes were too large. Plan your work accordingly.

Arrived when promised. Had a nice flat area where I inserted a light sensor. It had "punch outs" scores that were partial thickness - I had to drill them out with a paddle bit. It is not like the metal ones where you can punch them out. l liked them overall though. Would buy again.

Why did you pick this product vs others?:Perfect size. Great weather proof box for electric connections out to the shed. Great quality

When the product came it had a great build quality and mounting options.

This junction box is nice but the top does not have screws to keep it on. The top snaps together instead of being screwed on. It does seem like a good fit but I worry about weather changes and how well the top will stay securely together. I’m sure there is a place for this particular junction box but it does not meet my needs. Product was returned.

Why did you pick this product vs others?:Great service and on time delivery.