5 pack Electronic Prototype ABS Plastic Junction Project Box Enclosure 100mm by 60mm by 25mm for Portable, Arduino DIY (Black)

These are good, cheap plastic project boxes. They are not very scratch-resistant, and certainly not suitable for most professional applications. But, the soft plastic makes them very easy to work with small hobbyist tools. The tops are snap-fit, eliminating the inevitable problem of lost screws. Being soft plastic, you'll have to be careful to avoid using metal tools in the opening notches, or they will be marred.

Fits an UNO and a 9v battery, with some modification. Could be just a bit taller for my needs as so to fit soldered devices on the attached shield and then so I can put the cover on without pressing on those devices... Needed a little modification to fit the battery in there with the UNO - I had to hack openings in the end of the box to slide out the USB and power plugs. Seems like a sturdy box, decent made. I hope to make a couple of small UNO projects with these.

These are simple project boxes that do not require tool to open. The cover latches seem to be reasonably sturdy. The material does not appear to be easily cracked. Based on the construction and design, don't expect these boxes to be waterproof as is. There are no gaskets of any kind to keep water out. They are used indoor so cannot speak to weather resistance.

The 100 x 60 x 25mm box is a nice size for enclosing an esp32-s3-devkitC on an Electrocookie proto board with the abcde - fghij by 30 pin grid. ssss

Nicely built, easy to cut. Worked well for my project.

I had some old low voltage wiring in hallway from a doorbell I removed. Since I am using newer technology for a doorbell, the wiring isn’t needed but I didn’t want to just cut it or leave it dangling. I used one of these boxes to enclose the unused wiring. Just drilled a small hole in the back to insert wires and used double sided tape to affix to wall. Happy with it. Wiring available for use in future if needed.These are nice to have on hand. They look clean and aren’t too big. I’m sure they will all get used eventually.

I purchased the 5 pack for a few Pen-testing projects I’m doing and these boxes are the perfect fit! Quick access no screws to take out, you need it opened for quick access this is for you!

Nice little enclosure for small projects. Snap fit. Plastic is easy to drill / cut.Mentioning Arduino is a little confusing. Yes, it just fits an Uno, but there are no mounting screws for it. -- It's a generic case with four mounting standoffs in the corners.I'd be interested in a slightly thicker model which would give a little more room for things like shields and connections to the outside world.A decent value if you need a little project box.