HYPER GO16410S 1:16 Scale RC Car Upgrade Accessories Front Rear Metal Drive Shaft CVD Set, Spare Parts RC Vehicle Rotor Shafts for H16GT H16DR H16BM H16PL 16208 16210 16207(4 Pcs)

Buy these for your 1/16 hyper go! They are a breeze to install and worth every penny! I was going through plastic replacement ones like crazy since my sons the drive of the car and he’s not even 3 yet. They can stand up to a toddler and he loves to do flips off of walls and trees!

Perfect fit, works better than the plastic factory parts

Put these on my son's h16dr today. They worked, but I had to leave the inner bearing off because it was too small for the new shaft. He ran one 3s and two 2s batteries back to back with no issues. I'll get them again if need be.

Bought to replace broken drive axle on my HOSIM HB truck. Works great and gives me spare parts for both HB’s (17 & 26 models, pictured)

Our plastic hubs break easily on the H16-GT with light to mild abuse compared to videos. Not super hero built understandably. Purchased these metal units to improve the weak point of plastic hub. Unfortunately, once installed properly they bind up the rotation in rear shafts and somehow bind up the steering in the front. We tinkered with camber to allow more spacing but it doesn't help.Side note to the plastic versions installed and replacement shafts for HYPER GO H16GT, the hubs do not easily or even come close to fitting without sanding the hubs down so that the inner bearing fits on the plastic replacement.RATING: If something works but breaks or gives out early, it would be a rating higher than 1 or 2. If something is advertised to fit and does not I think that's a zero or 1.

Fits perfectly the mjx hypergo H16DR. No fit issues, and a great upgrade to the stock axles.

The tire shafts that came with the car broke quickly and repeatedly, so I purchased the metal upgrade and so far so good! They fit without any issues and should be much more durable with extended use.

I was skeptical of reviewers saying these were too long, so I tried them myself on the H16DR after breaking 4 plastic CV axles in about 3 weeks of driving.These fit ok-ish in the front, they make a clicking sound at full turn and the camber seems to be slightly altered. In the rear they do not fit at all and cause binding on the upper control arm which prevents the suspension from moving up and down. You can relieve the tension created by moving to the outward screw mount on the upper control arm, but unfortunately this drastically changes the camber and the car becomes extremely twitchy at speed.This product is misleading as the specs say it is compatible with H16DR.